How To Install A Decorative Ceiling Medallion

Installing a ceiling rose or ornamental medallion is an inexpensive way to add a dramatic effect to your room. Installing it by yourself is a fairly easy process so here’s a walkthrough of how to go about it.

Installing a ceiling improved or decorative medallion is an affordable way to add a dramatic effect for your area. Installing it on your own is a rather simple procedure so here is a walk through of how to begin doing it.

Pre-Installation. Primarily, take essential security measures by simply turning off the primary power to reduce electrocution and utilize a tester to be certain it’s off. Clean your ceiling until you begin to steer clear of any dust or debris getting in the way; utilizing a few gentle soap using a sponge can do good.

How To Install A Decorative Ceiling Medallion

Next, you need to lower the middle hole at the medallion in case it does not already have one. If the medallion does possess a pit, check to find out whether it enables the light fixture access to the wiring and then expand the gap if it does not. Depending on how big you need to cut the hole, then put the cover plate onto the medallion and draw lines.

How To Install Plaster Ceiling Medallion

How To Install Plaster Ceiling Medallion

Prior to bringing out the glue, test the meeting. Put the medallion so the centre allows access into the electric box. If the hole is not big enough to get most of cables, then it is possible to expand it with adhesive. Test to find out whether the amount of the bolt lets it attach the fixture into the junction box while the medallion is connected. Next, it is possible to paint your medallion to meet your walls and begin the installation.

How To Install A Ceiling Medallion

How To Install A Ceiling Medallion

Setup. Hold it by its own face and use a caulk gun to use the glue on the back of this medallion. Attach the medallion set up by positioning the centre over the junction box. Be certain that you twist the cover plate into the threaded bolt until the glue dries and then twist it so that it can secure the medallion into position.

Installing A Decorative Ceiling Medallion

Installing A Decorative Ceiling Medallion

Use a drill to drive screws beyond the medallion and within the ceiling so the medallion is mended. Be certain that you screw them in concealed places to prevent tarnishing the look. Remove the bolt and also the mounting bar then utilize nuts on the mounting bar to secure it into the threaded bolt. Pass your fixture’s cables through the spool and from the mounting bar and then twist it to the fixture.

Guide On Installing A Ceiling Medallion

Guide On Installing A Ceiling Medallion

Connect the cable in the junction box into the twist at the mounting bar. Twist the end of the wire using the ground wire from the fixture and also use a wire nut to fasten it. Connect the remaining cable to the black wire in the ceiling and then replace the cap plate by simply attaching it to the medallion. Turn the power back and respect the results.

Leave a Reply